YAESU VX-8DR 扩频方法
YAESU VX-8DR 扩频方法
扩频步骤：
- 开机。
- 按 SET 键 1 秒进入 SET 模式。
- 选择功能 #21 CWID。
- 旋转 DIAL 旋钮，将 CWID 设置为 (ON)。
- 按 MODE 键。
- 旋转 DIAL 旋钮选择 A，然后按 MODE 键。
- 旋转 DIAL 旋钮选择 H，然后按 MODE 键。
- 重复第 6-7 项操作，直到输完 AH029M，后接两个空格。
- 按 SET 键退出 SET 功能。
- 关机。
- 按住 HM/RV + MENU 键的同时开机。
- 旋转 DIAL 钮并配合 MODE 键，选择到三个星号：
***。 - 按 F 键。
- 关机。
- 重新开机，完成设定。
结果： 扩频成功后，设备可在 400MHz 全段发射等。
YAESU VX-8DR Frequency Expansion Method
Expansion Steps:
- Power on the device.
- Press and hold the [SET] key for 1 second to enter SET mode.
- Select function #21 CWID.
- Rotate the [DIAL] knob to set CWID to (ON).
- Press the [MODE] key.
- Rotate the [DIAL] knob to select \"A\", then press the [MODE] key.
- Rotate the [DIAL] knob to select \"H\", then press the [MODE] key.
- Repeat steps 6-7 until you have entered \"AH029M\" followed by two spaces.
- Press the [SET] key to exit the SET function.
- Power off the device.
- Press and hold the [HM/RV] + [MENU] keys while powering on.
- Rotate the [DIAL] knob and use the [MODE] key to select three asterisks:
***. - Press the [F] key.
- Power off the device.
- Power on again to complete the setup.
Result: After successful expansion, the device will be capable of full-band transmission on 400MHz, etc.